More work than it's worth. After cutting six sides, I realised they were too wide and had to start again and cut another six slightly less wide to fit with the hex bases. I was tempted to use thinner plastic sheets, but was afraid I wouldn't have sufficient surface on the edge to glue together. After carefully slicing the edges, I used one of the base as a template to glue together. I ended up gluing three together and then the two halves. Although the end result still looks a bit skewed, it may just be sufficient to serve its purpose. I may try the next one using slightly thinner plastic sheets and potentially add some inner corners if there is insufficient contact. Anyone suggest where I can just buy these? |