I used two trasparent Hex bases to start this off as I could not be bothered to create my own Hex shapes. Although in the end I needed the top padded so made at least one to top it off rather than use another transparent Hex base. The shielding and the protuding base support was all from scraps. I didn't even bother to use a previous one as template and just eye-balled the size and angles of the cut. My standards were dropping as some of the cuts were not straight that I usually then either sand down ot shave the other side. I just hope I don't regret it when I come to paint it... if I ever get around to it. I just hope the shielding stays glued onto the orange transparent rod in the middle. |