It started out nicely as I poured the Realistic Water onto the top part of the mountain. Using standard tape for both sides instead of the recommended masking tape. It poured too easily as I had thought it would be thicker. I had a few large visible bubbles that I managed to pop with a tooth pick against the side. Moving onto the lower section was more difficult due not having visibility of the alcove. Despite pouring a lot, the Realistic Water did not reach the edge so I continued to pour more, not realising it was leaking out a hole near the back. Matters became worse as I did not seal the tape as well as I thought and had a small leak at the back. With one third of the bottle used, hopefully this would dry and seal the holes so I can pour more to finish off the job. |