I'm glad that I have no plans to make more of these. Getting the angle correct was difficult especially when the front mount at a different height to the rear on the cannon. Then I had to ensure that the front was at the same angle than the back-end. It took a few attempts including slicing it off again to get it right. The layers were all by eyeballing the size using various large pieces of scrap. I didn't try and save any of the timmings as the scrap pile was getting increasingly large. There was ~two pieces that I had to redo as I trimmed them too small, but overall a suprising success. Especially that I managed to finish it on the same day! |