Normally I use Evergreen Strip Styrene rods, but they only produce them up to 3.2 mm rods. I needed at least 4 mm for the Tau drones so I got what seemed to be the best option off ebay. However ABS Styrene is a much harder material to work with. Manual sanding was not an option and I had to use the Dremel. It was hard to see the edges being sanded and I couldn't get the smoothness I wanted. To top off all the issues with working with ABS Styrene, even the Guillotine had difficulty making nice straight vertical cut. I just hope when I start gluing and painting with it there's less problems. |